RDM Connect EC9014 Bedienungsanleitung PDF herunterladen (Seite 6)

IM9235 - Split2.8 RDM User Guide

Front Panel Indicators

Each input has its own set of LED indicators that report on the status of that input port.

Data

Green - Indicates that DMX512 data is owing from input to all outputs (normal operation).

Red: Indicates that RDM data received by the outputs is being returned to the controller.

Power

Red - Indicates good power and normal operation.

Flashing - Indicates that a connected RDM device is ‘jabbering’ (returning unwanted data continuously).

RDM

RDM (Remote Device Management) is a PLASA Standards protocol from the Technical

Standard Program that allows Bi-Directional communication over standard DMX cable.

This enables a controller to have access to a DMX / RDM xtures conguration and to

alter this conguration remotely. The most obvious use is to be able to remotely set the

start address of the xture. However there are many other benets to RDM such as

sensor feedback, rmware uploads and automatic patching.

Split2.8 RDM fully supports the RDM protocol (E1.20 - 2006) but can also be used

within networks where there is no RDM present.

Power Supply

The internal power supply provides a universal input in the range of 90 to 250V AC via a

3 pin IEC C13 Connector.

The mains fuse should only be replaced with a 3.15A Slow Blow Fuse.

Earthing

The following table summarises the internal Earth interconnection and isolation:

Please note that we use the term Earth-Ground to avoid international confusions. In

Europe Earth-Ground is called Earth, in the USA Earth-Ground is called Ground.

Circuit Description

Chassis Bonded to Earth-Ground

DMX512 Input (including Loop

Through)

Type: Isolated

Pin 1: Connects to internal isolated circuit.

No connection to Earth-Ground

Shell: The connector shell is connected

to chassis

DMX512 Outputs Type: Grounded

Pin 1: Connected to Earth-Ground

Shell: The connector shell is connected

to chassis

Internal Logic Ground Connects to Earth-Ground

1 2 3 4 5 6 7 8

Keine Kommentare

RDM Connect EC9014 Bedienungsanleitung Seite 6